Filter
Top Products
44-6
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 44 Route Pattern Configuration
Route Pattern Configuration Settings
Calling Name
Presentation
Cisco Unified Communications Manager uses calling name presentation
(CNIP/CNIR) as a supplementary service to allow or restrict the originating
caller name on a call-by-call basis.
Choose whether you want the Cisco Unified Communications Manager to
allow or restrict the display of the calling party name on the called party phone
display for this route pattern.
Choose Default if you do not want to change calling name presentation.
Choose Allowed if you want Cisco Unified Communications Manager to
display the calling name information. Choose Restricted if you want Cisco
Unified Communications Manager to block the display of the calling name
information.
Calling Party Number
Type
Choose the format for the number type in calling party directory numbers.
Cisco Unified Communications Manager sets the calling directory number
(DN) type. Cisco recommends that you do not change the default value unless
you have advanced experience with dialing plans such as NANP or the
European dialing plan. You may need to change the default in Europe because
Cisco Unified Communications Manager does not recognize European
national dialing patterns. You can also change this setting when you are
connecting to a PBX that expects the calling directory number to be encoded
to a non-national numbering plan type.
Choose one of the following options:
• Cisco Unified Communications Manager—The Cisco Unified
Communications Manager sets the directory number type.
• Unknown—Use when the dialing plan is unknown.
• National—Use when you are dialing within the dialing plan for your
country.
• International—Use when you are dialing outside the dialing plan for your
country.
• Subscriber—Use when you are dialing a subscriber by using a shortened
subscriber number.
Table 44-1 Route Pattern Configuration Settings (continued)
Field Description