Filter
Top Products
90-94
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
Before You Begin
You must add an MGCP gateway before configuring ports. See the “Adding a Cisco IOS MGCP
Gateway” section on page 90-90 for instructions.
Procedure
Step 1 To display the Find and List Gateways window, choose Device > Gateway or skip to Step 4 if you have
already located the MGCP gateway to which you want to add FXO ports.
Step 2 Enter the appropriate search criteria to locate the MGCP gateway to which you want to add FXO ports
and click Find. The search results window displays.
Step 3 Click the name of the desired gateway to display its MGCP configuration settings and endpoint
identifiers.
Step 4 From the MGCP Configuration window, click the endpoint identifiers of the FXO port that you want to
configure.
Step 5 From the Port Type drop-down list box, choose either Ground Start or Loop Start.
Note You must choose the same port type for both endpoint identifiers of the VIC-2FXO port. If you
choose different port types, a message displays.
Step 6 Enter the appropriate Gateway Configuration and Port Information settings as described in the
following sections:
• FXS/FXO Port Configuration Settings, page 90-31
• Loop-Start Port Configuration Settings, page 90-84
• Ground-Start Port Configuration Settings, page 90-85
Step 7 Click Save.
Step 8 To return to the main MGCP gateway configuration window for the gateway to which you just added the
ports, choose Back to MGCP Configuration in the Related Links drop-down list box and click Go.
Step 9 To reset the gateway and apply the changes, click Reset.
Step 10 To add more FXO ports, repeat Step 4 though Step 7.
Additional Information
See the “Related Topics” section on page 90-104.
Adding Digital Access T1 Ports to an MGCP Gateway
Use this procedure to add Digital Access T1 (T1-CAS) ports to an MGCP gateway.
Step 1 To display the Find and List Gateways window, choose Device > Gateway or skip to Step 4 if you have
already located the MGCP gateway to which you want to add T1-CAS ports.
Step 2 To locate the MGCP gateway to which you want to add a Digital Access T1 (T1-CAS) port, enter the
appropriate search criteria.
Step 3 To display its MGCP configuration settings and endpoint identifiers, click the name of the desired
gateway.