Filter
Top Products
44-3
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 44 Route Pattern Configuration
Route Pattern Configuration Settings
Route Filter If your route pattern includes the @ wildcard, you may choose a route filter.
The optional act of choosing a route filter restricts certain number patterns.
The route filters that display depend on the numbering plan that you choose
from the Numbering Plan drop-down list box.
You can configure the number of items that display in this drop-down list box
by using the Max List Box Items enterprise parameter. If more route filters
exist than the Max List Box Items enterprise parameter specifies, the Find
button displays next to the drop-down list box. Click the Find button to display
the Find and List Route Filters window. Find and choose a route filter name by
using the
Finding a Route Filter procedure in the Cisco Unified
Communications Manager Administration Guide.
Note To set the maximum list box items, choose System > Enterprise
Parameters and choose CCMAdmin Parameters.
MLPP Precedence Choose an MLPP precedence setting for this route pattern from the drop-down
list box:
• Executive Override—Highest precedence setting for MLPP calls.
• Flash Override—Second highest precedence setting for MLPP calls.
• Flash—Third highest precedence setting for MLPP calls.
• Immediate—Fourth highest precedence setting for MLPP calls.
• Priority—Fifth highest precedence setting for MLPP calls.
• Routine—Lowest precedence setting for MLPP calls.
• Default—Does not override the incoming precedence level but rather lets
it pass unchanged.
Note Refer to the “Precedence” section in the “Multilevel Precedence and
Preemption” chapter of the Cisco Unified Communications Manager
Features and Services Guide for more information.
Resource Priority
Namespace Network
Domain
Choose a Resource Priority Namespace Network Domain from the drop-down
list box. To configure the Resource Priority Namespace Network Domains,
choose System
> MLPP > Namespace > Resource Priority Namespace
Network Domain. Refer to the Cisco Unified Communications Manager
Features and Services Guide for more information.
Gateway/Route List Choose the gateway or route list for which you are adding a route pattern.
Note If the gateway is included in a Route Group, this drop-down list box does
not display the gateway. When a gateway is chosen in the drop-down
list box, Cisco Unified Communications Manager uses all the ports in
the gateway to route/block this route pattern. This action does not
apply for MGCP gateways.
Table 44-1 Route Pattern Configuration Settings (continued)
Field Description