Filter
Top Products
97-5
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 97 Device Profile Configuration
Device Profile Configuration Settings
Always Use Prime Line for
Voice Message
From the drop-down list box, choose one of the following options:
• On—If the phone is idle, the primary line on the phone becomes
the active line for retrieving voice messages when the phone user
presses the Messages button on the phone.
• Off—If the phone is idle, pressing the Messages button on the
phone automatically dials the voice-messaging system from the
line that has a voice message. Cisco Unified Communications
Manager always selects the first line that has a voice message. If no
line has a voice message, the primary line gets used when the phone
user presses the Messages button.
• Default—Cisco Unified Communications Manager uses the
configuration from the Always Use Prime Line for Voice Message
service parameter, which supports the Cisco CallManager service.
Ignore Presentation
Indicators (internal calls
only)
To configure call display restrictions and ignore any presentation
restriction that is received for internal calls, check the “Ignore
Presentation Indicators (internal calls only)” check box.
Tip Use this configuration in combination with the calling line ID
presentation and connected line ID presentation configuration
at the translation pattern level. Together, these settings allow
you to configure call display restrictions to selectively present
or block calling and/or connected line display information for
each call. For more information about call display restrictions,
refer to the
Call Display Restrictions chapter in the Cisco
Unified Communications Manager Features and Services
Guide.
Do Not Disturb Check this check box to enable Do Not Disturb.
DND Option When you enable DND on the phone, this parameter allows you to
specify how the DND feature handles incoming calls:
• Call Reject—This option specifies that no incoming call
information gets presented to the user. Depending on how you
configure the DND Incoming Call Alert parameter, the phone may
play a beep or display a flash notification of the call.
• Ringer Off—This option turns off the ringer, but incoming call
information gets presented to the device, so that the user can accept
the call.
• Use Common Phone Profile Setting—This option specifies that
the DND Option setting from the Common Phone Profile window
will get used for this device.
Note For 7940/7960 phones that are running SCCP, you can only
choose the Ringer Off option. For mobile devices and
dual-mode phones, you can only choose the Call Reject option.
When you activate DND Call Reject on a mobile device or
dual-mode phone, no call information gets presented to the
device.
Table 97-1 Device Profile Configuration Settings (continued)
Field Description