Filter
Top Products
90-3
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Gateway Configuration Settings
Configured Slots, VICs, and Endpoints
Note You must specify the beginning port number for some VICs. For example, if the VIC in
Subunit 0 begins at 0 and has two ports (0 and 1), the VIC in Subunit 1 must begin at a port
number greater than 1 and have two ports (2 and 3 or 4 and 5).
Note The correct number of slots displays for each model of MGCP gateway. (The VG200 gateway
has only one slot.)
Note To begin configuring ports on a module, select the module first; then, click Save.
Module in Slot 0
Module in Slot 1
Module in Slot 2
Module in Slot 3
(and so on)
For each available slot on the chosen MGCP gateway, choose the
type of module that is installed; for example:
• NM-1V—Has one voice interface card (VIC) in Subunit 0 for
FXS or FXO. When you use the VIC-2BRI-S/T-TE card with a
NM-1V module, you can make two calls because the second
BRI port is shut down.
• NM-2V—Has two VICs, one in Subunit 0 and one in Subunit 1
for either FXS or FXO. When you use the VIC-2BRI-S/T-TE
card with a NM-2V module, you can make four calls. If another
VIC is in the second slot of the NM-2V, the second port on the
VIC-2BRI-S/T-TE gets shut down.
• NM-HDV—Has one VIC in Subunit 0 for either T1-CAS or
T1-PRI, or E1-PRI.
• NM-HDA—Has three VICs, one in Subunit 0, one in Subunit 1,
and one in Subunit 2.
• VWIC-SLOT—Has a slot for any of the following modules:
VIC (FXS, FXO, or BRI), T1-CAS, T1-PRI, or E1-PRI.
• AIM-VOICE-30—Has two VICs, one in Subunit 0 and one in
Subunit 1 for T1-CAS, T1-PRI, or E1-PRI.
• WS-X6600-24FXS—Has 24 FXS ports.
• WS-X6600-6T1—Has six ports for T1 PRI or CAS.
• WS-X6600-6E1—Has six ports for E1 PRI.
• WS-SVC-CMM-MS—Has two port adapters, one for a T1
interface and one for an E1 interface for Europe and other
countries.
• None—Has no network modules installed.
Table 90-1 MGCP Gateway Configuration Settings (continued)
Field Description