Filter
Top Products
41-4
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 41 Route Filter Configuration
Configuring a Route Filter
Configuring a Route Filter
The following procedure describes how to configure a route filter.
Procedure
Step 1 From Cisco Unified Communications Manager Administration, choose Call Routing > Route Filter.
Step 2 Perform one of the following tasks:
• To copy an existing route filter, locate the appropriate route filter as described in the “Finding a
Route Filter” section on page 41-2, click the Copy button next to the route filter that you want to
copy, and continue with Step 3.
• To add a new route filter, click the Add New button and continue with Step 3.
• To update an existing route filter, locate the appropriate route filter as described in the “Finding a
Route Filter” section on page 41-2, and continue with Step 3.
Step 3 In the Route Filter Configuration window that displays, enter the appropriate settings as described in
Table 41-1, Table 41-2, and Table 41-3.
Step 4 To add the route filter, click Save.
Note Refer to the “Synchronizing a Route Filter With Affected Devices” section on page 41-6 before
deciding whether to proceed to Step 5 below.
Step 5 If you are updating a route filter, click Reset Devices. Resetting the devices that are associated with the
route filter causes calls on affected gateways to drop.
Additional Information
See the “Related Topics” section on page 41-10.
Adding and Editing Route Filter Clauses
Adding route filter clauses allows you to expand upon an existing route filter by incorporating additional
operators and entries for existing tags by using a logical OR. You can add route filter clauses either when
initially adding a new route filter or when updating an existing route filter.
Editing route filter clauses allows you to modify an existing route filter clause.
This procedure describes adding and editing route filter clauses that comprise an existing route filter.
Procedure
Step 1 From Cisco Unified Communications Manager Administration, choose Call Routing > Route Filter.
Step 2 Locate the route filter to which you want to add or edit route filter clauses. See the “Finding a Route
Filter” section on page 41-2.
Step 3 If you want to add a new route filter clause, click Add Clause to display a new Route Filter Clause
Configuration data entry window. All the operator fields for this new clause display NOT-SELECTED.