Filter
Top Products
47-13
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 47 Hunt Pilot Configuration
Configuring a Hunt Pilot
Before You Begin
Ensure that the following items are configured in Cisco Unified Communications Manager:
• Hunt list
• Partition (unless you are using <None>)
• Route filter (unless you are using <None>)
Timesaver Assigning 8XXX to a hunt pilot causes hunting through all directory numbers 8000 to 8999. Similarly,
82XX hunts through directory numbers 8200 to 8299. See the
“Special Characters and Settings” section
in the Cisco Unified Communications Manager System Guide for more information about wildcards.
Procedure
Step 1 Choose Call Routing > Route/Hunt > Hunt Pilot.
The Find and List Hunt Pilots window displays.
Step 2 Perform one of the following tasks:
• To copy an existing hunt pilot, locate the appropriate hunt pilot as described in “Finding a Hunt
Pilot” section on page 47-11. Click the Copy button next to the hunt pilot that you want to copy. The
window displays the copy of the hunt pilot. Change the value in the Hunt Pilot field, and continue
with
Step 3.
• To add a new hunt pilot, click the Add New button and continue with Step 3.
• To update an existing hunt pilot, locate the appropriate hunt pilot as described in “Finding a Hunt
Pilot” section on page 47-11, and continue with Step 3.
Step 3 Enter the appropriate settings as described in Table 47-1.
Step 4 Click Save.
Note After you choose a hunt list from the Hunt List drop-down list box, you can use the (Edit) link
that displays next to the Hunt List field to take you to the Hunt List Configuration window for
the hunt list that you choose. Use the Hunt List Configuration window to see the line group(s)
that are included in that hunt list.
Additional Information
See the “Related Topics” section on page 47-14.