Filter
Top Products
97-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 97 Device Profile Configuration
Device Profile Configuration Settings
You can also assign a user device profile to be the default logout device profile for a particular device.
When a user logs out of a phone, for instance, the logout device profile loads onto the phone and gives
that phone the attributes of the logout device profile. In the Cisco Unified Communications Manager
Administration windows, you can create, modify, or delete the user device profile. If a user device profile
is used as the logout device profile, you cannot delete the user device profile.
Cisco Unified Communications Manager also supports a device profile default. Use the device profile
default for whenever a user logs on to a phone model for which no user device profile exists. To create
a device profile default for each phone model that supports Cisco Extension Mobility, use the Device
Profile Default Configuration window. The maximum number of device profile defaults cannot exceed
the number of phone models that support Cisco Extension Mobility. For more information about the
device profile default, see the
“Default Device Profile Configuration” section on page 96-1.
Before You Begin
Make sure that phone button template(s) are already configured before you configure the device profile.
See the
“Configuring Phone Button Templates” section on page 98-3 for more information.
Table 97-1 describes the available settings in the Device Profile Configuration window. For more
information about related procedures, see the “Related Topics” section on page 97-11.
Table 97-1 Device Profile Configuration Settings
Field Description
User Device Profile Information
Product Type This field displays the product type to which this device profile applies.
Device Protocol This field displays the device protocol to which this device profile
applies.
Device Profile Name Enter a unique name. This name can comprise up to 50 characters in
length.
Description Enter a description of the device profile. For text, use anything that
describes this particular user device profile.
User Hold MOH Audio
Source
To specify the audio source that plays when a user initiates a hold
action, choose an audio source from the User Hold MOH Audio Source
drop-down list box.
If you do not choose an audio source, Cisco Unified Communications
Manager uses the audio source that is defined in the device pool or the
system default if the device pool does not specify an audio source ID.
Note You define audio sources in the Music On Hold Audio Source
Configuration window. For access, choose Media Resources
>
Music On Hold Audio Source.