Filter
Top Products
90-98
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
Step 6 Enter the appropriate settings, depending on whether you are configuring a Digital Access PRI interface
or a Digital Access T1 interface as described in following sections:
• Digital Access PRI Port Configuration Settings, page 90-39
• Digital Access T1 Port Configuration Settings, page 90-62
Step 7 Click Save.
Step 8 If you are configuring a Digital Access T1 interface on a Catalyst 6000 T1 VoIP Gateway, in the Ports
pane that displays on the left side of the window, click Add a New Port link to configure ports.
See the “Adding Digital Access T1 Ports to an MGCP Gateway” section on page 90-94.
Step 9 To reset the gateway and apply the changes, click Reset.
Additional Information
See the “Related Topics” section on page 90-104.
Adding a Cisco IOS H.323 Gateway
Perform the following procedures to add a Cisco IOS H.323 Gateway to Cisco Unified Communications
Manager.
Note After a gateway is registered with Cisco Unified Communications Manager, gateway registration status
may display in Cisco Unified Communications Manager Administration as unknown.
Before You Begin
Before configuring a Cisco IOS H.323 gateway for use with Cisco Unified Communications Manager,
you must configure the gateway by using the Cisco IOS command-line interface (CLI). Compared to
MGCP gateways, H.323 gateways require more configuration on the gateway because the gateway must
maintain the dial plan and route pattern. For procedures and commands that are required to perform this
configuration, refer to the configuration documentation that is supplied with the gateway.
Procedure
Step 1 To display the Find and List Gateways window, choose Device > Gateway.
Step 2 Click the Add New button.
The Add a New Gateway window displays.
Step 3 From the Gateway Type drop-down list box, choose H.323 Gateway.
Step 4 Click Next.
Step 5 Enter the appropriate settings as described in “H.323 Gateway Configuration Settings” section on
page 90-4.
Step 6 Click Save.
Step 7 To reset the gateway and apply the changes, click Reset.