Filter
Top Products
3. Tool Offset (L system)
3.2 Tool Length Data
I
-87
Refer to "3 (II). Tool Offset (M system)" for M system.
< Measuring procedure for the measuring value input method >
(1) Select the TOOL DATA screen.
(2) Set the tool No. to be measured in #
( ).
(Select the tool before this step. It can
be selected using a manual numerical
command.)
(3) Cut the surface corresponding to the
axis to be measured.
To measure the X axis, cut the workpiece
in the longitudinal direction.
(For the Z axis, execute face turning.)
(4) Do not retract the tool at the finish point
of the cutting, but press address key o
f
the axis to be measured.
[TOOL DATA] TOOL 2.1/4
[MACHINE] X 212.350
#I :INC. #A :ABS Y 210.100
#1 X 0.000 Z 0.000
2 X 0.000 Z 0.000
3 X 0.000 Z 0.000
:
:
T M
# ( 1 ) X ( )
Z ( )
(Example)
Select tool length No."1".
X-axis measurement
X
In this way the machine coordinate
values of the measured axis are
stored in the memory. They are
canceled by pressing the same key
twice.
∗ Also repeat steps (3) and (4) for
the Z axis
X axis measurement...
# ( 1 ) X ( ) Z ( )
(Note 1)
(Note 2)
Character is reversed.
(5) Retract the tool, and stop the spindle.
(6) Measure the workpiece, and set the measurement values in the setting areas of each axis. Set the
values for all axes shown in highlighted characters.
(Example)
# ( 1 ) X (10.0) Z (35.
0 )
(Note 3)
X-axis diameter command example
Cutting surface
Measurement
basic point
10.0Ø
35.0