Filter
Top Products
6. Data In/Out
6.4 PROGRAM COPY
I-257
6.4.1 Machining Program Copy
A machining program selected among work programs registered in memory can be copied as another
program having a different program number. The source program remains intact.
Set 1 in # ( ) for the copy command. Set the program number of the copy source program and the program
number of new program.
Press the
INPUT
key.
(Example)
To copy program O1000 into O2000
# ( 1
)
O ( 1
0 0 0 )
→
O ( 2 0 0 0 )
# ( 1 )O ( 1000)
→
O( 2000)
COPY EXECUTION
# ( 1 ) O( 1000)
→
O( 2000)
COPY COMPLETE
# ( ) O( )
→
O( )
1) A copy is started and the
message "COPY EXECUTION" is
displayed in the message field. It
may be terminated in a moment
(when there is less copy data).
2) When the copy is complete, the
message "COPY COMPLETE" is
displayed in the message field.
(Note 1) When using the 2-part system, the machining program copy operation can be switched with the
parameters.
#1050
MemPrg
#1285
ext21/bit0
Details
0, 2, 4, 6 - Of the machining programs registered in the memory common for the systems,
the designated machining program is copied to the memory common for the
systems with a different machining program number.
1, 3, 5, 7 OFF Of the machining programs registered in the memory for the selected systems,
the designated machining program is copied to the memory for the selected
system as a different machining program number.
ON Of all the machining programs registered in the memory for each system, the
designated machining program is copied to the memory for each system with a
different machining program number.
(Note 2) When using the 2-part system and the same number batch generation for all system programs is
valid, an error (E64) will occur if the copy destination program is found in any of the systems.