Filter
Top Products
9. Graphics
9.6 SCALE
I-363
(2) Using the tool position as the display range center
For example, assume that the tool
mark is not in the screen center,
and a drawing is made as shown at
the right.
TRACE EXECUTION
Press the keys
SHIFT
and
C.B
CAN
.
TRACE EXECUTION
1) The tool mark appears in the screen
center.
2) If the message "TRACE EXECUTION"
appears, consecutive drawing is made.
(Note)
SHIFT
+
C.B
CAN
function
This function displays the current machine
position in the screen center.
1) This operation cannot be carried out while any one of SCALE, GRF MODE, ROTATION, or CHECK
SEARCH is valid.
2) The machine position is not moved in program check mode, even if drawing is carried out.
Therefore, the tool center cannot be displayed in the center of the screen, even with the above key
operation.
3) However, both the drawing and machine position move in the trace mode, so the tool center can be
displayed in the center of the screen with the above key operation.
(Example) Changing the scale and display
position simultaneously
To enlarge the graphics (shown at
the right) in the screen center,
carry out the following operations:
TRACE EXECUTION