Filter
Top Products
3. Tool Offset (L system)
3.2 Tool Length Data
I
-89
Refer to "3 (II). Tool Offset (M system)" for M system.
3.2.2 Manual Numeric Command Operation on the TOOL DATA Screen (M, T)
When carrying out a manual numeric command of the TOOL OFFSET screen, the mode must first be
changed from the normal data setting mode to the manual numeric command mode. M and T commands
can be executed by screen operation in this mode.
(1) Changing from the normal data setting mode to the
manual numerical command mode
A cursor appears in the data setting area in the normal
data setting mode, but a cursor does not appear in the
manual numerical command mode. Confirm that the
mode has changed over by checking this difference. The
operation is as follows:
T M
#( )DATA ( )
Set
M
(manual) in the first set of
parentheses in the setting area.
T M
#( M )DATA ( )
1) This operation is the same for M or T
commands.
Press the
INPUT
key. The mode
changes to the manual numerical
command mode.
T M
#( )DATA ( )
1) The data in the setting area is cleared, and
the cursor disappears from the screen.
(2) Executing the manual numeric command ..... Carry out this step after (1) above.
1. Press the address key corresponding to the command. The display area of the corresponding
command value is highlighted, and a manual numeric command input status results. Execute tool
function commands with
T
, and miscellaneous function commands with
M
.
2. Key-input the numerical value to be commanded.
3. Press the
INPUT
key. The command is executed.
(Note) The manual numeric command operation is the same as the operation on the POSITION screen.
Refer to the section on manual numeric commands for the MONITOR and POSITION screens for
details.
(3) Operation for returning the mode from the manual numeric command mode to the normal data setting
mode
Press the
key. The normal data
setting mode returns.
T20 M6
#( )DATA ( )
1) The cursor appears in the first set of
parentheses, and the normal setting mode is
enabled.