Filter
Top Products
2. Monitor
2.5 Resuming the Program
I-57
(Note 1) Restart type 3 is valid only with the lathe system.
(Note 2) When using the 2-part system, the system name of the currently selected system is displayed as
$1 (system 1) and $2 (system 2). This is not displayed when using a 1-part system. (Only L
system)
(Note 3) When using the 2-part system, the methods for searching for the program and block to be
restarted can be switched with the parameters.
#1050
MemPrg
#1285
ext21/bit0
Details
0, 2, 4, 6 - The machining program block registered in the memory common for
systems is searched.
1, 3, 5, 7 OFF The machining program block registered in the memory for the selected
system is searched.
ON The machining program block registered in the memory for the selected
system is searched.
If the subprogram for the selected system is empty, the corresponding
block is searched from the program with the same number saved in the
$1 memory. (Only type B)