Filter
Top Products
8. High-speed Program Server
8.4 IC card
I-345
8.4.5 Searching for a Machining Program in the IC Card
The machining program is searched for with the following operations.
(1) Set #4 and the program No. (1 to 99,999,999) to be searched.
(Example) To search for program 1000.
# (4) 0 (1000)
# ( 4 ) 0 ( 1000)
(2) Press the
INPUT
key.
The program search will start, and "
SEARCH EXECUTION
" will appear in the message area.
SEARCH EXECUTION
# ( 4
) 0 ( 1000)
(3) When the search is completed, "
SEARCH COMPLETE
" will appear in the message area, and the program
No. setting area will become blank.
SEARCH COMPLETE
# ( ) 0 (
)
(4) To start the program that was searched and found, press the Automatic Start switch in the tape mode.
The search state is held until reset is input. (When reset, the program must be searched for again.)
(Note) Searching is not possible unless the machining program format is correct. (The machining program
format is explained later.)