Filter
Top Products
8. High-speed Program Server
8.4 IC card
I-342
8.4.2 Outputting a Machining Program to the IC Card (NC to IC)
The following operations are used to output the machining program.
(1) Set #2 and the program No. (1 to 99,999,999).
(Example) To output program 1000 from the NC memory to the IC card.
# (2) 0 (1000)
# ( 2
) 0 ( 1000)
(2) Press the
INPUT
key.
The program output will start, and "
DATA OUT EXECUTION
" will appear in the message area.
DATA OUT EXECUTION
# ( 2 ) 0 ( 1000)
(3) When the output is completed, "
DATA OUT COMPLETE
" will appear in the message area, and the program
No. setting area will become blank.
DATA OUT COMPLETE
# ( ) 0 (
)
(Note1) The screen cannot be changed during data output.