Filter
Top Products
6. Data In/Out
6.1 DATA INPUT
I-226
6.1.2 Machining Program Input
To input a user-prepared machining program, perform the following:
(1) When inputting the program number output onto tape.
The program can be input simply by specifying machining program data type #1. If the program number
is specified, the number on tape takes precedence over that number.
1) Data input is started.
The program number being
entered is displayed in the setting
area.
2) When normal data input is
executed to the end and the EOR
code is read, data input is
terminated.
Press the
INPUT
key.
Set the data type.
# ( 1
) DATA ( )
# ( 1 ) DATA ( )
<INPUT DATA>
O1234 (TEST-PRO.#1) ;
<COMP. DATA>
DATA IN EXECUTION
# ( 1 ) DATA ( 1234)
<INPUT DATA>
%
<COMP. DATA>
DATA IN COMPLETE
# ( ) DATA ( )
E E E E E E
O O O 1234(TEST-PRO,#1) O N1G28 X0 Y0 Z0 O N2 M02 O O
R B B B B R
Program main unit Program number and comment
CAUTION
" ; " "EOB" and " % " "EOR" are explanatory notations. The actual codes are "Line feed" and "%" for
ISO, and "End of Block" and "End of Record" for EIA.
To prevent influence from data omission and data transformation in the communication
circuit, always verify the data after inputting and outputting machining programs.