Filter
Top Products
Precautions for Safety
Always read the specifications issued by the machine maker, this manual, related
manuals and attached documents before installation, operation, programming,
maintenance or inspection to ensure correct use.
Understand this numerical controller, safety items and cautions before using the unit.
This manual ranks the safety precautions into "DANGER", "WARNING" and "CAUTION".
DANGER
When the user may be subject to imminent fatalities or major
injuries if handling is mistaken.
WARNING
When the user may be subject to fatalities or major injuries if
handling is mistaken.
CAUTION
When the user may be subject to bodily injury or when physical
damage may occur if handling is mistaken.
Note that even items ranked as "
CAUTION", may lead to major results depending on
the situation. In any case, important information that must always be observed is
described.
DANGER
Not applicable in this manual.
WARNING
1. Items related to operation
If the operation start position is set in a block which is in the middle of the program and
the program is started, the program before the set block is not executed. Please confirm
that G and F modal and coordinate values are appropriate. If there are coordinate system
shift commands or M, S, T and B commands before the block set as the start position,
carry out the required commands using the MDI, etc. If the program is run from the set
block without carrying out these operations, there is a danger of interference with the
machine or of machine operation at an unexpected speed, which may result in breakage
of tools or machine tool or may cause damage to the operators.
Under the constant surface speed control (during G96 modal), if the axis targeted for the
constant surface speed control moves toward the spindle center, the spindle rotation
speed will increase and may exceed the allowable speed of the workpiece or chuck, etc.
In this case, the workpiece, etc. may jump out during machining, which may result in
breakage of tools or machine tool or may cause damage to the operators.