Filter
Top Products
3. Tool Offset (M system)
3.1 Tool Offset
I
-117
Refer to "3 (I). Tool Offset (L system)" for L system.
(3) Tool offset data setting by tool length measurement
OFFSET REGIST LIFE MENU
[TOOL OFFSET] TOOL 1.1/ 2
#A:ABS. #I:INC. [MACHINE] Z 0.000
SURFACE #O = 50.000
#
1 0.000 11 300.000
2 50.000 12 50.000
3 100.000 13 250.000
4 0.000 14 50.000
5 100.000 15 150.000
6 60.000 16 80.000
7 20.000 17 200.000
8 150.000 18 150.000
9 20.000 19 500.000
10 0.000 20 100.000
T 0 M
#( ) DATA( )
1) Tool length measurement I
Position the tool to the machine coordinate
zero point.
START
Select a measurement tool.
Set the absolute value setting mode.
Turn ON the machine operation board
"TLM" switch.
Move the tool to the measurement point b
y
making jog feed or manual handle feed.
Upon completion of measurement, specif
y
the tool offset number.
Select the TOOL OFFSET screen.
Enter
A
in # ( ), then press the
INPUT
key. "#A: ABS." is displayed in reverse
video.
To message "TLM" is displayed on the
TOOL OFFSET screen.
0 is displayed in DATA ( ) field.
The measurement value is displayed in
DATA ( ) field in sequence.
The measurement value is also displayed
under [TLM].
The current value of the measurement axis
is displayed under [MACHINE] Z.
Set the offset number in # ( ) and press
the
INPUT
key.
The measurement data is displayed at the
position of the specified offset number.
Setting and display on the TOOL
OFFSET screen
(Note)
For operation procedure, see Machine Operation manual.