Filter
Top Products
6. Data In/Out
6.3 PROGRAM ERASE
I-255
(4) Precautions for 2-part system
When using the 2-part system, the machining program erase operation can be switched with the
parameters.
#1050
MemPrg
#1285
ext21/bit0
Details
0, 2, 4, 6 - Of the machining programs registered in the memory common for the
systems, the designated machining program is erased.
1, 3, 5, 7 OFF Of the machining programs registered in the memory for the selected
systems, the designated machining program is erased.
ON Of all the machining programs registered in the memory for each system,
the designated machining program is erased.
When using the 2-part system and the same number batch generation for all system programs is valid,
the program is erased in the following manner according to the presence of programs in each system.
Presence of program
System 1 System 2
Operation
Yes Yes The System 1 and System 2 programs are erased simultaneously.
Yes No Only the System 1 program is erased.
No Yes Only the System 2 program is erased.
No No An error (E14) occurs.