Filter
Top Products
6. Data In/Out
6.4 PROGRAM COPY
I-260
6.4.3 Machining Program Merge
To prepare a new machining program by using the machining program contents stored in memory, one
machining program can be followed by a copy of another program. The two programs are merged into a new
program.
Set 3 in # ( ) for the merge command. Set the copy source and destination program numbers in order.
Press the
INPUT
key.
(Example 1)
To move program O1001 to the area
following program O1000 for merge
# ( 3
)
O ( 1
0 0 1 )
→
O ( 1 0 0 0 )
# ( 3 ) O( 1001)
→
O( 1000)
MERGE EXECUTION
# ( 3 ) O( 1001)
→
O( 1000)
MERGE COMPLETE
# ( ) O( )
→
O( )
1) Merge is executed and the
message "MERGE EXECUTION"
is displayed in the message field. It
may be terminated in a moment
(when there is less transfer data).
2) When the merge is completed, the
message "MERGE COMPLETE" is
displayed in the message field.
(Example 2) When program O1002 is moved to the area following program O1000 for merge after
operation in (Example 1) above, a new program is prepared as shown below. The three
programs are merged into O1000. O1001 and O1002 remain unchanged.
(Empty)
(Empty)
(Program O1001)
(Program O1002)
250
characters
(Empty)
O1000
(Program O1000)
(Program O1001)
(Program O1002)
O1001
O1002
Marge
Marge
250
characters
250
characters
250
characters