Filter
Top Products
2. Monitor
2.4 PROGRAM SEARCH
I-49
2.4.1 Memory Search
Any work program is called from the machining programs registered in memory before work.
Set the program number to be called, the sequence number, and block number. Set the tape search setting
area to 0. The initial state when power is turned ON is memory search.
Press the
INPUT
key.
O ( 1234) N ( 20) - ( ) COL. ( ) TAPE(0)
SEARCH EXECUTION
O ( 1234) N ( 20) - ( ) COL. ( ) TAPE(0)
[PROGURAM SEARCH] MONITOR 4. 1/4
O1234 N 20-0
<SUB> O 0 N 0-0
[PROGRAM FILE]
100
200
300
400
1234
[COLLATION BLOCK]
O N -
SEARCH COMPLETE
O( ) N( )-( ) COL. ( ) TAPE(0)
1) A search is started.
2) When the specified program
number, sequence number, and
block number are found,
SEARCH COMPLETE message
is displayed.
The found numbers are displayed
in O and N. Data in the found
block is displayed in the work
program display area.
Set the program number to be
called. Set the sequence number
and block number as required.
(
Example
)
To call O1234 N20 block,
O ( 1 2 3 4 ) N ( 2 0 ) - ( )
COL. ( ) TAPE (0)
(Note 1) If one of the following operations is executed in the EDIT screen after memory search, the system
enters a status in which nothing is being searched. Operation is disabled at this time. In this case,
execute the search again.
• Deleting the program being searched.
• Deleting the sequence number for which the search was being executed.
• Deleting the block corresponding to the block number for which the search was being
executed.
(Note 2) One block which the control unit executes in one automatic start cycle can be searched in this
case. The block with ; (EOB) or sequence number only is not regarded as a one cycle execution
block. Axis movement command or control command such as M, S, or T is contained in it.