Filter
Top Products
2. Monitor
2.3 COMMAND
I-46
Display item Explanation
The rotation angle for the program coordinate rotation command is
displayed.
The scaling magnification is displayed.
G68: R= (M system)
G51: P= (M system)
G05: P10000 (M system)
The high-speed machining mode and high-speed high-accuracy
mode are displayed.
High-speed machining mode 3 (G05 : P3)
High-speed high-accuracy control II (G05 : P10000)
SSS control valid (G05 : P10000S)
High-speed high-accuracy control I (G05.1 : Q1)
Spline interpolation (G05.1 : Q2)
Mode OFF (G05 : P0)
Tx: –12.345 (L system)
Tz: 12.345 (L system)
Tc: 10.000 (L system)
The total of the X axis, Z axis and additional axis' tool length and
wear compensation amounts for the tool being used is displayed.
Tg: 12 (L system)
Tw: 12 (L system)
The tool length offset No. is displayed.
The wear compensation No. is displayed.
v (L system)
FA 24000.00
FM 1200.00
FS 0.0000
FE 0.0000 (L system)
S 12345
T 1234
M 12345678 10 35 40
B 1234
The constant surface speed spindle rotation speed is displayed.
The program command asynchronous feedrate modal value
currently being executed is displayed. (mm/min)
The manual feedrate is displayed. (mm/min)
The program command synchronous feedrate modal value
currently being executed is displayed. (mm/rev)
The thread lead command synchronous feedrate modal value
currently being executed is displayed. (mm/rev)
The modal value of the current program command S being
executed is displayed.
The modal value of the current program command T being
executed is displayed.
A maximum of four modal values of the current program command
M being executed are displayed.
The second miscellaneous function modal value of the current
program command being executed is displayed.
N300 G1X-100.234~ The current program block being executed is displayed.