Filter
Top Products
8. High-speed Program Server
8.4 IC card
I-341
8.4.1 Inputting a Machining Program from the IC Card (IC to NC)
The following operations are used to input the machining program.
(1) Set #1 and the program No. (1 to 99,999,999).
(Example) To input program 1000 from the IC card to the NC memory.
# (1) 0 (1000)
# ( 1 ) 0 ( 1000)
(2) Press the
INPUT
key.
The program input will start, and "
DATA IN EXECUTION
" will appear in the message area.
DATA IN EXECUTION
# ( 1 ) 0 ( 1000)
(3) When the input is completed, "
DATA IN COMPLETE
" will appear in the message area, and the program No.
setting area will become blank.
DATA IN COMPLETE
# ( ) 0 (
)
(Note1) Programs being called by the M198 command cannot be input.
(Note2) The screen cannot be changed during data input.