Filter
Top Products
3. Tool Offset (M system)
I-111
Refer to "3 (I). Tool Offset (L system)" for L system.
3 (II). Tool Offset (M system)
The following menu will display if the function selection key
TOOL
PARAM
is pressed.
TOOL menu
No.1 to 4
TOOL
OFFSET
#1 to #20
or #1 to #10
T-
REGISTRATION
MG 1 to MG 20
TOOL
LIFE
:
:
# to #
WORK
PROCESS I/O BASE
PARAM
SETUP
PARAMETER
CONTROL
AXIS
BARRIER
PARAM
Refer to PARAMETERS.
#1 to #40
or #11 to #20
MG 61 to MG 80
MG 41 to MG 60
MG 21 to MG 40
TOOL DATA
:
:
TOOL DATA
PARAM menu display (No.1 to 4)
TOOL menu display (No.1 to 4)
OFFSET REGIST LIFE MENU
Menu selection keysPrevious page key Next page key
WORK PROCESS I/O PAR SETUP MENU
PREVIOUS
PAGE
NEXT
PAGE
PARAM menu
(No.1 to 4)
PREVIOUS
PAGE
NEXT
PAGE
PARAM
PARAM
PARAM
MENU
CAUTION
If a tool offset or workpiece coordinate system offset is changed during automatic operation
(including during single block stop), the new offset is validated from the command of the next block
or blocks onwards.