Filter
Top Products
5. Program
5.5 Edit Screen Extension Operation
I-191
(3) Sequence number, block number search
Specify the called program number, sequence number, and block number in the setting area. If only
digits are set in N ( ), a sequence number search is made. (If an alphabetic character or symbol is
contained, a character string search is made.) To search the top of a program, specify only the program
number. To search an already displayed program on the screen for a given sequence number, program
number specification may be omitted.
The operation procedure is described
below.
SEARCH MAKE SMALL FILE
O 1000 EDIT
N1 G28 X0Y0Z0 ;
N2 G92 X0 Y0 Z0 ;
N3 G00 X-300. Y-300. F2000;
N4 G01 X-200.;
N5 Y-200.;
N6 X200.;
N7 Y200.;
M02 ;
%
SEARCH MAKE LARGE FILE
O( ) N ( ) - ( )
Press the menu key
SEARCH
.
(1)
1) The setting area for "SEARCH" is
displayed.
Set the called program number,
sequence number, and block
number.
(Example)
O ( ) N ( 6) - ( )
(2)
SEARCH MAKE LARGE FILE
O( ) N ( 6 ) - ( )
SEARCH MAKE LARGE FILE
SEARCH EXECUTION
O( ) N ( 6 ) - ( )
Press the
INPUT
key.
(3)
1) The message "SEARCH EXECUTION" is
displayed during searching.
2) A search for a given N number is started at
the top of the specified program. The
program is displayed starting at the block
containing the found N number. However, for
the program already displayed on the
screen, a search for the specified N number
is started at the displayed portion.
3) The cursor is displayed at the top of the
found block.
4) At normal completion of search, display of
the setting area disappears and SEARCH
menu display is restored to normal mode
from reverse mode.
SEARCH MAKE LARGE FILE
O 1000 EDIT
N6 X200.;
N7 Y200.;
M02 ;
%
(Note 1) When a given N number is not found, an "NB NOT FOUND" message is displayed.
(Note 2) If a given program number is not found, a "PROG NOT FOUND" message is displayed.
(Note 3) The sequence number can be specified in a maximum of five digits.