Filter
Top Products
9. Graphics
9.4 Use of the Check Modes
I-355
(3) Line types during checking
During tool nose
radius compensation
Not during tool nose
radius compensation
Manual feed — —
Program path Broken line —
Rapid traverse
Tool center path Broken line Broken line
Program path Solid line —
Cutting feed
Tool center path Solid line Solid line
(4) Relation with other functions
Function name
Graphic
check
Remarks
Coordinate system
rotation
Figure rotation function
Decimal point input
command
Either Type I or Type II is possible.
Mirror image function
Refer to (6) Precautions, item 4.
Z axis cancel function ×
The path is drawn exactly as the commanded
movement.
Interlock ×
External deceleration ×
Override ×
Feed hold ×
Cycle start ×
If CYCLE START is pressed during checking, a
"CHECK EXECUTION" alarm will appear while it is held
down.
Auto-restart × CHECK COMPLETE occurs with M02/M30.
Workpiece coordinate
system offset
This is set at the position determined by the offset
amount actually set.
Local coordinate system
offset
Same as above.
Compare stop function ×
The operation does not stop even if the set stop block is
executed.
Helical interpolation
function
× Drawn with straight lines.