Filter
Top Products
3-43
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 3 Adding and Troubleshooting Devices Using Device Management
Checking and Viewing Device Credentials
The report displays the number of devices that were selected for credential verification, and lists the
devices for which the report is not available.
Table 3-11 describes the Credential Verification Report Status messages:
The device credentials verification result displays No Value To Test for the AUS-managed devices (PIX
devices). This is because RME communicates with the AUS using username and password through http
protocol.
The SNMP and Telnet or SSH credentials are not required. Any communication to an AUS managed
device (PIX devices) does not happen directly, but only through AUS.
Ta b l e 3-11 Understanding Credential Verification Report
Status Message Description
OK Check for device credentials completed. The device credentials data in the
Device and Credential Repository matches the physical device credentials.
No authentication
configured
Device was not configured with authentication mechanism
(Telnet/LocalUsername/TACACS).
RME was able to telnet and log into the device successfully with out using
the values entered in the Device and Credential Repository.
Incorrect Check for device credentials completed.
The device credentials data in the Device and Credential Repository does
not match with the physical device credentials for one of the following
reasons:
• The device credentials data in Device and Credential Repository is not
correct.
• The device is unreachable or offline.
• One of the interfaces on the device is down.
Did Not Try Check for device credentials is not performed for one of the following
reasons:
• A Telnet password does not exist, so could not log into the device.
• Device Telnet login mode failed, so enable mode login is not
attempted.
No Value To Test Check for device credentials is not performed because you have not
entered the device credentials data.
Not Supported Check for Telnet passwords is not performed because Telnet credential
checking is not supported on this device.
Failed Check failed because a Telnet session could not be established due to a not
responding device.
Click on the Failed link to view the error message.
Credentials not Verified Specific credentials were not verified because they were not selected for
verification.