Filter
Top Products
9-58
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
For each device category, click on Applicable Devices to view the devices in your selection, to which
the reload task applies.
SNMP Community Configuration Task
You can use the SNMP Community Configuration system-defined task to replace, add, and remove
device SNMP community strings.
The following device categories are supported by this task:
• IOS (including Cable devices)
• Catalyst OS
• Content Engine
• CSS
• NAM
• PIX OS
For more details, see Table 9-3.
You can enter the details of this task in the SNMP Community Configuration dialog box. (To invoke this
dialog box, see
Starting a New NetConfig Job.)
CE Parameters Do not Save
config before
reload
Action You can:
• Check this option if you do not want to save the
configurations before reloading.
or
• Uncheck this option if you want to save the configurations
before reloading.
NAM Parameters Do not Save
config before
reload
Action You can:
• Check this option if you do not want to save the
configurations before reloading.
or
• Uncheck this option if you want to save the configurations
before reloading.
SFS Parameters No category-specific parameters.
Fast Switch
parameters
No category-specific parameters.
PIX Parameters No category-specific parameters.
CSS Parameters No category-specific parameters.
Cable Parameters Do not Save
config before
reload
Action You can:
• Check this option if you do not want to save the
configurations before reloading.
or
• Uncheck this option if you want to save the configurations
before reloading.