Filter
Top Products
14-46
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 14 Enabling and Tracking Syslogs Using Syslog Analyzer and Collector
Generating a Standard Report
You can click on any of the field titles to sort the report based on that field.
Generating a Standard Report
You can generate a system message report for a device or set of devices. You can run a report for a date
or range of dates and base the report on the message severity or alert types. All Syslog reports display
message log information.
Note When you are generating a Standard Report, you may get an outofmemory exception. This may occur if
the number of syslog messages that were generated in the date range that you specified in the report job,
exceeded six hundred thousand. Decrease the period, that is, specify a shorter date range, and run the
report job again.
To generate the report, see Overview: Syslog Analyzer Reports.
Fields in the Standard Report:
Informational Number of informational messages received from the device.
Debugging Number of debug messages received from the device.
Field Description
Field Description Link
Device Name Name of a device (switch or router) that caused the Syslog message. None.
Interface The IP address of the interface through which the syslog was sent out. None.
Timestamp Date and time the message was logged. This is the timestamp provided
by the device. Syslog Analyzer provides a timestamp if the device does
not send one.
None.
Facility-SubFacility • Facility is a hardware device, a protocol, or a module of the system
software; for example, SYS. Refer to the Cisco IOS reference
manual System Error Messages for a predefined list of facility
codes.
• SubFacility is the subfacility in the device that generated the Syslog
message. In most cases, this is blank. An example of an entry in this
field is
SYS-5-CONFIG I.
None.
Severity Message severity level, from informational (6) to emergency (0). None.
Mnemonic Code that uniquely identifies the error message. Note that older Catalyst
messages do not display a mnemonic. An example of a mnemonic for an
IOS message is CONFIG I.
None.