Filter
Top Products
8-23
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 8 Archiving Configurations and Managing Them Using Archive Management
Setting Up Archive Management
• Cisco 1003 Router (Device Type) level
ip name-server,banner motd,snmp-server manager session-timeout
While comparing configurations, only the Cisco 1003 Router (Device Type) level commands are
excluded.
Example 2:
If you have specified these commands only at Device Family and Device Category,
• Routers (Device Category) level
end,exec-timeout,length,width,certificate,ntp clock-period
• Cisco 1000 Series Routers (Device Family) level
banner incoming,snmp-server location
• Cisco 1003 Router (Device Type) level
No commands specified.
While comparing configurations, only the Cisco 1000 Series Routers (Device Family) level commands
are excluded.
If the commands are specified only at the Device Category level, these commands are applicable to all
devices under that category.
To configure Exclude Commands:
Step 1 Select Resource Manager Essentials > Admin > Config Mgmt > Archive Mgmt > Exclude
Commands.
The Configure Exclude Commands dialog box appears.
Step 2 Select one of these from the Device Type Selector pane:
• Device Category (For example, Routers, Wireless, etc.)
• Device Family (For example, Cisco 1000 Series Routers, Cisco 1400 Series Routers, etc.)
• Device Type (For example, Cisco 1003 Router, Cisco 1401 Router, etc.)
Step 3 Enter the command in the Exclude Commands pane to add new commands.
You can enter multiple commands separated by commas.
You can also edit or delete the existing commands in the Exclude Commands pane.
Step 4 Click Apply.
A message appears, The commands to be excluded are saved successfully.
Configuring Fetch Settings
You can configure the Job Result Wait Time per device for the Sync Archive Jobs. The default value is
120 seconds. The minimum value can be set to 60 seconds.
Job Result Wait Time is the maximum wait time that Archive Management waits to get the
configurations from the device during the sync-archive job execution.
To configure the Job Result Wait Time: