Filter
Top Products
9-47
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
For each device category, click on Applicable Devices to view the devices in your selection, to which
this task applies.
IGMP Configuration Task
You can use this task to configure the Internet Group Management Protocol (IGMP) on a cable interface.
Note You can apply this task only on a single IOS device at a time. For details, see Table 9-3.
You can enter the details of this task in the IGMP Configuration dialog box. (To invoke this dialog box,
see
Starting a New NetConfig Job.)
For the features of system-defined tasks and a description of the features of a system-defined task dialog
box, see
Understanding the System-defined Task User Interface (Dialog Box).
The fields in the IGMP Configuration dialog box are:
Group Sub-group Field Description
IOS Parameters
IGMP
Configuration
Interface Interfaces Select the required option to specify the interface to be configured
for IGMP, or to make no change to the existing interface selection:
• Not Selected
• FastEthernet0/0
• FastEthernet0/
• Cable1/0
Action Select the required option to enable, disable, or make no change to
the Interface sub-group of fields.
PIM Mode Select the required PIM mode option. Select No Change to retain any
previous mode selection:
• No Change
• dense-mode
• sparse-mode
• sparse-dense-mode
IGMP
Parameters
Action Select the required option to replace the values in, or to make no
change to the IGMP Parameters group of fields.
IGMP Version Select the required IGMP version from the supported versions:
• 1
• 2
• 3