Filter
Top Products
9-87
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
Click Available Devices to view the list of devices from your selection, to which this task applies
Cable Interface Bundling Task
You can use this task to configure the interface bundling. You can apply this task only to a single
Cable-CMTS device at a time.
This task is applicable to the Cable device category. For more details, see Table 9-3.
You can enter the details of this task in husbanded Configuration dialog box. (To invoke this dialog box,
see
Starting a New NetConfig Job.)
Apply Token
Bucket
Algorithm
Click the check box to apply this option.
Enable Traffic
Shaping
Click the check box to apply this option.
Data Backoff Data Backoff Select the required data backoff option. The options are:
• No Change—Does not modify the existing configuration.
• Enable—Enables this option.
• Disable—Disables this option.
If you choose Enable, you can perform data back off automatically,
or manually by entering the start and end values.
Automatic Choose this to apply a default value for data automatically.
Start Value [0-15] Enter the start value.
The valid range for the start value is 0—15. there is no default
value.
End Value [0-15] Enter the end value.
The valid range for the end value is 0—15. there is no default
value.
Range Backoff Range Backoff Select one of these options:
• No Change—Does not modify the existing configuration.
• Enable—Allows you to perform data back off automatically,
or manually by entering the start and end values.
• Disable—Disables this option.
Automatic Select this, to apply a range back-off value automatically.
Start Value (0-15) Enter the start value.
The valid range for the start value is 0-15. There is no default
value.
End Value (0-15) Enter the end value.
The valid range for the start value is 0-15. There is no default
value.
Group Sub-Group Field Description