D-2
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Appendix D Managing Devices When RME Server is Within a NAT Boundary
Configuring RME Server for the NAT Environment
This is the public, or the outside IP address of the RME server.
Only those devices that are added to the system after the default is set, will use the new Natted RME IP
Address value.
All existing devices will have to be edited using this procedure to set the Natted RME IP Address value
when a part of the network is outside the NAT boundary:
Step 1 Navigate to Resource Manager Essentials > Device Management > RME Devices.
The RME Devices dialog box appears.
Step 2 Select the required devices.
Step 3 Click Edit Device Attributes.
For the complete procedure to change the RME ID, see the topic Editing RME Device Attributes in the
section Adding and Troubleshooting Devices Using Device Management.
When you configure devices that are outside the NAT boundary, for Syslog and trap destinations using
NetConfig templates, you must use the translated outside address of the receiving server as the
destination address.