Filter
Top Products
9-76
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
Transform System-Defined Task
You can use the Transform system-defined task to configure IPSec on devices. You must configure the
IKE configuration system-defined task before configuring the Transform system-defined task.
This task supports the following device categories:
• IOS (including Cable devices)
• PIX OS
For more details, see Table 9-3.
You can enter the details of this task in the Transform Set Configuration dialog box. (To invoke this
dialog box, see
Starting a New NetConfig Job.)
For the features of system-defined tasks and a description of the features of a system-defined task dialog
box, see
Understanding the System-defined Task User Interface (Dialog Box).
The fields in the Transform Set Configuration dialog box are:
Password Enter the Telnet password.
Veri fy Re-enter the Telnet password to confirm.
Apply command
on modules
Disable will set
an empty
password
Select this option to update only the non IP addressable modules.
If you select the Action as Disable, the password will be removed.
PIX
Parameters
Action Select the required option to replace, reset, or make no change to the
password.
Password Enter the password.
Veri fy Re-enter the password to confirm.
Encrypted
Password
Select this option, if the password you are entering is already encrypted.
Group Sub-group Field Description
Group Sub-Group Field Description
IOS Parameters
Security
Association
Configuration
Seconds
Configuration
Seconds
[120-86400]
Enter number of seconds that will be used for negotiating
IPSec SA.
Remove Select this option to remove any previously specified
seconds value.
Kilo Bytes
Configuration
Kilo Bytes
[2560-536870912]
Enter the amount of traffic in kilobytes that will be used
for negotiating IPSec SA.
Value must be between 2560-536870912.
Remove Select this option to remove any previously specified
kilobytes value.