Filter
Top Products
9-49
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
Interface IP Address Configuration Task
You can use this task to configure the IP address of a cable interface.
Note You can apply this task only on a single IOS device at a time. For details, see Table 9-3.
You can enter the details of this task in the Interface IP Address Configuration dialog box. (To invoke
this dialog box, see
Starting a New NetConfig Job.)
For the features of system-defined tasks and a description of the features of a system-defined task dialog
box, see
Understanding the System-defined Task User Interface (Dialog Box).
The fields in the Interface IP Address Configuration dialog box are:
Note The values for interfaces are as returned by device.
Click on Applicable Devices to view the devices in your selection, to which this task applies.
Group Sub-group Field Description
Cable
Parameters
Interface IP
Configuration
Cable Interface Select the required cable interface for configuring the IP
address, or select Not Selected to make no change to any
previous selection:
• Not Selected
• FastEthernet0/0
• FastEthernet0/1
• Cable1/0
Action Select the required action:
• No Change—Makes no change to the IP Addresses
• Replace—Replaces the IP Addresses
• Remove Primary—Removes the primary IP Address.
• Remove Secondary—Removes the secondary IP Address.
• Remove All—Removes both primary and secondary IP
Addresses.
IPAddress Primary Enter the primary IP address.
Secondary Enter the secondary IP address.
Subnet Mask Primary Enter the primary subnet mask.
Secondary Enter the secondary subnet mask.