Filter
Top Products
9-57
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 9 Making and Deploying Configuration Changes Using NetConfig
Using System-defined Tasks
The fields in the RCP Configuration dialog box are:
For each device category, click on Applicable Devices to view the devices in your selection, to which
this task applies.
Reload Task
You can use the Reload task to schedule reload of devices. This task supports the IOS, Cat OS, SFS,
NAM, CE, FastSwitch, PIX, CSS and Cable categories of devices. For more details, see
Table 9-3.
You can enter the details of this task in the Reload Configuration dialog box. (To invoke this dialog box,
see
Starting a New NetConfig Job.)
For the features of system-defined tasks and a description of the features of a system-defined task dialog
box, see
Understanding the System-defined Task User Interface (Dialog Box)
The fields in the Reload Configuration dialog box are:
Group Sub-group Field Description
IOS Parameters Enable Action Select to enable or disable rcp state.
To make rcp setup changes without enabling or disabling rcp,
select No Change.
RCP User Setup Action Select the required option to add to, or to remove current user
from rcp authentication list.
To make rcp setup changes without enabling or disabling rcp,
select No Change.
Local Username Enter local name of user whose rcp access you are modifying.
Remote Host Enter IP address of remote host from which local device will
accept remotely executed commands.
Remote
Username
Enter username on remote host from which device will accept
remote commands.
Enable Mode
Commands
Click to allow remote user to run enable commands using rsh or
to copy files to device using rcp.
add/remove Click add to add current user to rcp authentication list.
Click remove to remove current user from rcp authentication list.
Group Sub-group Field Description
IOS Parameters Do not Save
config before
reload
Action You can:
• Check this option if you do not want to save the
configurations before reloading.
or
• Uncheck this option if you want to save the configurations
before reloading.
CatOS
Parameters
No category-specific parameters.