Filter
Top Products
19-83
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Chapter 19 CLI Utilities
CWCLI
Usage Examples for cwcli inventory cda Command
This section provides some examples of usage for the cwcli inventory cda command.
Example 1: Invoking the Check Device Attributes
cwcli inventory cda -u admin -p admin -invoke -device 3750-stack
The command output is:
CDA invoked for given device and credType list
SUMMARY
========
Successful: CDA: Success
Ta b l e 19-2 Understanding Credential Verification Report
Status Message Description
OK Check for device credentials completed. The device credentials data
in the Device and Credential Repository matches the physical device
credentials.
No authentication configured Device was not configured with authentication mechanism
(Telnet/LocalUsername/TACACS). RME was able to telnet and log
into the device successfully with out using the values entered in the
Device and Credential Repository.
Incorrect Check for device credentials completed. The device credentials data
in the Device and Credential Repository does not match with the
physical device credentials for one of the following reasons:
• The device credentials data in Device and Credential Repository
is not correct.
• The device is unreachable or offline.
• One of the interfaces on the device is down.
No Data Yet Check for device credentials is in progress.
Did Not Try Check for device credentials is not performed for one of the following
reasons:
• A Telnet password does not exist, so could not login to the device.
• Device Telnet login mode failed, so enable mode login is not
attempted.
No Value To Test Check for device credentials is not performed because you have not
entered the device credentials data.
Not Supported Check for Telnet passwords is not performed because Telnet
credential checking is not supported on this device.
Failed Check failed because a Telnet session could not be established due to
a not responding device.
Not Selected For Verification Protocol was not selected for verification.