Filter
Top Products
A-77
User Guide for Resource Manager Essentials 4.1
OL-11714-01
Appendix A RME Troubleshooting Tips and FAQs
Software Management
SWIM1051 Credential information
cannot be obtained for the
device.
Either:
• The device is not
managed in the RME
server
Or
• The device credentials
are not correct or the
device access privileges
are insufficient.
None.
SWIM1052 Enable password is not
configured for the device.
For Run For Flash (RFF)
partition software upgrades,
the Enable password must be
configured.
Configure the Enable password in the
credentials repository.
SWIM1053 Selected MICA Image is
the same as the running
image on the device.
The software version of the
image is the latest on the
device.
None.
SWIM1054 Error while checking the
Telnet credential of the
device.
None. Make sure that the Telnet credentials for the
device are correct.
SWIM1055 Selected Flash partition is
ReadOnly.
Either the Flash partition is
not write-enabled or the
Read-Write partition does not
exist.
Check whether the Read-Write partition
exists. Set the Flash partition to be
write-enabled.
SWIM1056 The method to update the
software on the selected
storage device is unknown.
None. Select a different Flash partition, if available.
SWIM1057 The device will be put into
Rxboot mode for the image
upgrade.
None. Select a different Flash device for the system
software, if available.
SWIM1058 The selected software
version has some known
problems in the Flash MIB
options which will make
this application unable to
perform software upgrades
on the device.
None. Upgrade the device manually or select a later
software version, if available.
SWIM1059 Ensure Dial Shelf runs a
compatible software image
with the newly loaded
Router Shelf software
image.
The Router shelf software
image is not compatible with
the Dial Shelf software
image.
See the Release Notes for the Router Shelf
software image to make sure the current Dial
Shelf software is compatible.
If not, upgrade the Dial Shelf software.
SWIM1060 Cannot obtain the file size
of the selected image.
The selected image may have
been removed from
Cisco.com.
Select another image for upgrading.
Message-ID Error Message Probable Cause Possible Action